How to Program Sanyo TV Without Using Codes

Have you lost the manual for your universal remote, or have you tried all the recommended codes for your Sanyo TV without success? Don’t worry—there is still a powerful method that requires no codes at all. It’s called the Auto-Code Search.

This feature is built into almost every universal remote and works by scanning through the remote’s entire internal library of codes, one by one, until it finds a match for your Sanyo TV. It can take a few minutes, but it’s one of the most reliable ways to get connected.

This guide will show you how to use the two most common types of Auto-Code Search.

Before You Begin

• Turn your Sanyo TV on manually.
• Make sure you have fresh batteries in your universal remote.
• Sit in front of your TV, as you will need to stop the scan as soon as the TV responds.

Method 1: The “Press and Wait” Scan

This method is common on brands like RCA. The remote does most of the work for you after a quick setup.

1. Enter Programming Mode: Press and hold the Setup or Code Search button on your remote until the indicator light (usually red) turns on and stays solid.
2. Select the Device: Press and release the TV button. The indicator light should remain on.
3. Start the Scan: Press and release the Power button on the universal remote. The indicator light will begin to blink, showing that the remote is now testing and sending codes to your TV.
4. Be Ready to Stop: This is the most important step. The remote will continue sending signals until your TV suddenly turns off.
5. Lock in the Code: The moment the TV powers down, immediately press the Enter or OK button to save the code. If your remote has no Enter button, pressing the Power button again will often work to save it. The indicator light will turn off.
6. Test It: Turn your TV back on with the remote and test the Volume, Channel, and Mute buttons to confirm that everything is working as it should.

Method 2: The “Manual Step-by-Step” Scan

This method, common on Magnavox and many other brands, requires you to manually advance through the codes. It gives you more control over the process.

1. Enter Programming Mode: Press and hold the Setup or Code Search button until the indicator light turns on and stays solid.
2. Select the Device: Press and release the TV button. The light will remain on.
3. Cycle Through Codes: Aim the remote at the TV and begin to repeatedly press and release the Power button(or on some remotes, the CH+ button). Pause for a second between each press.
   • How It Works: Each button press sends the next code in the remote’s library.
4. Stop When the TV Turns Off: Continue pressing the button until your TV powers down. Stop immediately.
5. Lock in the Code: To save the code, press the Enter or Mute button once. The indicator light will blink a few times and then turn off, confirming the code is stored.
6. Test It: Turn the TV back on and check all the main functions.
   • Pro Tip: If you accidentally pass the correct code, some remotes allow you to press the CH- button to go backward through the list.

Frequently Asked Questions

Conclusion:

Programming a Sanyo TV without codes is easy and effective with the Auto-Code Search method. While it requires a bit of patience, it’s the ultimate solution when you don’t have a code list handy. By following the steps for your type of remote, you can successfully sync your devices and get back to enjoying your entertainment system with the convenience of a single controller.